Ecosoft CROSS 90 User Manual

4
INSTALLER AND USER GUIDE FOR CROSS 90 DIRECT FLOW REVERSE OSMOSIS FILTER
This manual is the intellectual property of Ecoso. Copying and reprinng is prohibited. © 2023
1. PURPOSE OF THE PRODUCT
№ Parameter Value
1 Main pressure, bar 1-4 *
2 Feed water temperature, °C +5…+30**
3 Flow capacity, l/min 1,5
4 Electrical rang 230 V, 50 Hz
5 Weight of the system, kg 11
6 Ambient temperature, °C +5…+40
7 Water supply connecon ½″ thread
8 Filter dimensions, H × W × D, mm 458 x 140 x 435
2. SPECIFICATIONS AND COMPONENTS
2.1 SPECIFICATIONS AND REQUIREMENTS
Inside the membrane, water is separated into two streams: concentrate, which is discharged into
drain, and permeate, which enters next step – post-lter (7).
Aer opening the puried water valve (3), the pressure in the system drops and the high pressure
switch is acvated, opening the inlet valve and starng the pump, automacally resuming the
ow of water through the pretreatment cartridge to the membrane. Aer opening the puried
water valve (3), the pressure in the system drops and the high pressure switch is acvated,
opening the inlet valve and starng the pump, automacally resuming the ow of water through
the pretreatment cartridge to the membrane. The puried water aer the membrane enters
the fourth stage of puricaon — the CB carbon post-lter, designed for nal water puricaon.
The puried water aer the membrane enters the fourth stage of puricaon — the CB carbon
post-lter, designed for nal water puricaon. It contains extruded acvated carbon. This lter
improves the taste and smell of the puried water. This lter is direct-ow, so no water storage
tank is required. With a capacity of 600 GPD (90 l/h), it takes only 8 seconds to ll a 200 ml glass.
* If supply water pressure is below required value, purchase pumped model or t your exisng
lter with booster pump. If the pressure in the water system is above the limit, it is necessary to
install a pressure regulator on the main pipe. If pressure in tank bladder is outside this range, it is
necessary to pump up or release the pressure unl it conforms to the requirement.
** If supply water temperature is up in the range of +20…+30 °C, rejecon of impuries will be
decreased and system capacity increased, bringing about an increase in TDS. Using the product
with supply water temperature in excess of +30 °C is not recommended.

Ecosoft CROSS 90 Specifications

General

Brand	Ecosoft
Model	CROSS 90
Category	Water Filtration Systems
Language	English