5
EN
INSTALLER AND USER GUIDE FOR CROSS 90 DIRECT FLOW REVERSE OSMOSIS FILTER
This manual is the intellectual property of Ecoso. Copying and reprinng is prohibited. © 2023
№ Index Value**
1 pH 6.5-8.5
2 TDS <1500 ppm
3 Hardness
<500 ppm CaCO
3
(<28 °dH)
4 Free chlorine <0.5 ppm
5 Iron <0.3 ppm
№ Index Value
1 pH 5.5-6.5
2 TDS 5-15 ppm
3 Calcium <2 ppm
4 Magnesium <1 ppm
5 Sodium + Potassium <5 ppm
№ Index Value**
6 Manganese <0.1 ppm
7
Chemical oxygen
demand
<5 ppm O
2
8
Total bacterial count
(TBC)
<50 CFU/mL
9 E. coli ter <3
2. SPECIFICATIONS AND COMPONENTS
2.2 WATER QUALITY
2.2.1 SUPPLY WATER QUALITY REQUIREMENTS*
2.2.2 WATER QUALITY AFTER FILTER*
Do not use with water that is microbiologically unsafe or of unknown quality without adequate
disinfecon before or aer the system.
* If water supply does not meet the requirements, service life of membrane and/or pre-lter
cartridges may be shortened.
** If your home is supplied with raw well water, perform laboratory test of your water before
in- stalling a reverse osmosis lter. If any of your water indices exceed the limit, consider using a
water treatment system to correct supply water quality. Refer to water treatment specialists or
companies for advice and proper equipment selecon.
* Values are determined under the following
condions: temperature of supply water is
25 °C, supply water quality and operaon
condions correspond to manufacturer’s
requirements.
To Next Page
Loading...
Need help?
General
