Ecosoft CROSS 90 User Manual (English)

Questions and Answers:

L
lisahayesAug 3, 2025
What to do if my Ecosoft Water Filtration System will not switch on?
- D
  David ClineAug 3, 2025
  If your Ecosoft Water Filtration System doesn't switch on, here are a few things to check: * Make sure all valves on the supply water pipes are open and check for any clogs or obstructions. * If the low or high pressure switch is defective, replace the switch and check the contact group. * If the pump overrun protection has been triggered, try disconnecting and reconnecting the electrical connection.
J
Jasmine CarterAug 7, 2025
Why is the Ecosoft Water Filtration System switching on and off repeatedly?
- G
  George AguilarAug 7, 2025
  The Ecosoft Water Filtration System may repeatedly switch on and off because of surges in feed water pressure just above the low pressure switch setting. To resolve this, eliminate pressure surges and check the supply water piping for clogs or other obstructions, removing them if present.
K
Kathryn RodriguezAug 11, 2025
What to do if my Ecosoft Water Filtration System will not switch off?
- H
  Howard PattonAug 12, 2025
  If your Ecosoft Water Filtration System will not switch off, it is likely due to a high pressure switch failure. Replace the high pressure switch and verify proper electrical contact.
F
Frank FergusonAug 16, 2025
What to do if my Ecosoft Water Filtration System has switched off but continues to send water to drain?
- B
  Brandi MeyerAug 16, 2025
  If your Ecosoft Water Filtration System continues to send water to the drain after it has switched off, it is likely due to a solenoid valve failure. Replace the solenoid valve to resolve this issue.
K
Kristin MarshallAug 20, 2025
How to fix slow water flow from my Ecosoft Water Filtration Systems faucet?
- D
  Douglas CarrilloAug 20, 2025
  If the water flow from your Ecosoft Water Filtration Systems faucet is slow, there are several potential causes. High noise or a clogged CF filter could be the issue, so try replacing the CF filter or straightening the tube. Additionally, measure the permeate flow rate; if it takes twice as long (or more) to produce 1 liter of water (more than 40 seconds), the membrane may need replacement. High water supply pressure can also cause slow flow, so install a pressure regulator or consult a plumber if necessary.