8
INSTALLER AND USER GUIDE FOR CROSS 90 DIRECT FLOW REVERSE OSMOSIS FILTER
This manual is the intellectual property of Ecoso. Copying and reprinng is prohibited. © 2023
— verify that your product is as specied in paragraph 2.1;
— verify that your supply water quality** meets the requirements in paragraph 2.2.
**If supply water quality does not meet the requirements, it is necessary to consult with a
water treatment specialist.
3) Before installing the system, make sure there is enough space for the lter rack under the sink.
4) Electrical safety noce: This appliance should be connected into a circuit with an RCB installed.
Please note voltage requirements.
5) Install the system per the guidelines of this manual.
6) The unit is to be supplied with single-phase 230 VAC, 50 Hz electrical power.
The unit is supplied with power cord and can be connected to a properly installed IEC 60884-1
compliant socket. Electrical specicaon of the unit can be found on manufacturer’s factory
scker. That system and installaon must comply with state and local laws and regulaons.
3.2 СONNECTION DIAGRAM
3.3 INSTALLATION PROCEDURE
Wash your hands thoroughly with an-bacterial soap before handling tubes, cartridges, and
membrane.
This system should desirably be installed in places protected from direct sunlight and away
from heang appliances.
3. FILTER INSTALLATION
3/8” White pipe
1/4” Red pipe
1/4” White pipe
To Next Page
Loading...
Need help?
General
