Ecosoft ROBUST 1000 Installer And User Guide

40
This manual is the intellectual property of Ecoso. Copying and reprinng is prohibited. © 2016
INSTALLER AND USER GUIDE FOR REVERSE OSMOSIS SYSTEM ECOSOFT ROBUST 1000, ROBUST 3000
6 Put a few turns of PTFE tape on tank nipple thread.
Screw tank valve on the tank nipple. Turn the valve
fully o.
NOTE! Test air pressure in the empty tank bladder
(remove the cap on the lateral boom to access
valve stem). Reading should be 0.6–1.0 bar (8.7–
14.5 psi). If necessary, use the air pump to inate the
bladder. If pressure is too high already, push on the
valve stem’s core to relieve it.
7 Install the faucet.
7.1 To install puried water faucet 8 bore a hole with di-
ameter of 12.5 mm (0.49″) in the desired locaon on
sink or coun tertop.
CAUTION! Metal shavings can damage your sink, re-
move them carefully once you have nished drilling.
If the mounng surface is stone or ceramic, use a
carbide drill bit.
7.2 Mount the faucet over the hole on top of small rub-
ber washer, chrome plated base, and large rubber
washer. Fix the faucet rmly with plasc washer, lock
washer, and nut put on the faucet shank underneath
sink surface.
7.3 Put compression nut on the free end of the blue
tube, then put on the ferrule and the insert inside
the tube.
7.4 Push the end of the blue tube inside the shank
boom a few cenmeter deeper, seat the ferrule
against shank boom and the screw compression
nut snugly on shank thread. The faucet should now
be rmly xed on the top of sink, and the blue tube
ghtly seated in compression ng at the boom of
the faucet shank.
8 Remove 1
st
and 2
nd
pre-lter housings (le to right), put the polypropylene lter in the rst
bowl, carbon lter in the second.
9 Install the housings back on the system frame. Hand ghten only.
10 Prepare a suitable water container. Remove feed water tubes from the two rst stage mem-
brane housings and place the free ends in the prepared container. Open main shuto valve
and the system feed valve to start rinsing pre-lters. Collect running water in the container
and discard when full. Repeat unl there are no carbon nes in the rinse water. Install the
free tube ends back in push-t ngs in membrane housings and lock with locking clips.
PTFE tape
PTFE tape
tank valve
small rubber gasket
chrome-plated cover
blue tube
large rubber gasket
large plasc gasket
lock washer
nut
counter
1/4 ferrule
1/4 compression nut
plasc insert

Ecosoft ROBUST 1000 Specifications

General

Brand	Ecosoft
Model	ROBUST 1000
Category	Water Dispenser
Language	English