ECOVACS Winbot 9 - Maintenance; Cleaning Pad Maintenance; Component Cleaning and Care

13
ENEN
4. Maintenance
Turn the robot over and remove the Cleaning
Pad. Rinse the Cleaning Pad and allow it to dry
completely before re-attaching it to the robot.
Before performing cleaning and maintenance on WINBOT 9, move the Bottom Power Switch
to the
“
O
”
position and unplug it from the receptacle.
4.1 Cleaning Pad
4.2 Cupule, Sensors, Squeegee, Corners
Do NOT use a wet Cleaning Pad
on WINBOT 9, or it may slip on the
window.
*
Cupule
Edge Detection Sensors
Wheel Sensor
Turn the robot over and wipe any debris from
the surface of the Cupule with the provided
Finishing Cloth to maintain suction.
Turn the robot over and wipe the four Edge
Detection Sensors clean with the provided
Finishing Cloth to maintain their effectiveness.
Squeegee
Turn the robot over and wipe the Squeegee
clean with the provided Finishing Cloth
to maintain its effectiveness.
Turn the robot over and wipe the Wheel
Sensor with the provided Finishing Cloth
to maintain its effectiveness.