35
Chapter 3: BIOS Setup Utility
Delay 4 Sec. then you have to hold the power button down for four seconds to
cause a software power down.
HPET Support
This item enables or disables HPET support.
Resume by PCI PME
This system can be turned off with a software command. If you enable this
item, the system can automatically resume if there is an incoming call on the
PCI Modem card or PCI LAN card. You must use an ATX power supply
inorder to use this feature. Use this item to do wake-up action if inserting the
PCI card.
Resume by WOM/Ring
An input signal on the serial Ring indicator (RI) line (in other words, and
incoming call on the modem)/LAN awakens the system from a soft off state.
Resume By USB (S3)
This item allows users to enable or disable the USB device Walk-up from S3
mode.
Resume By PS2 MS/KB (S3)
These items enable or disable you to allow mouse or keyboard activity to awaken
the system from power saving mode.
Power On By Button
This item enables or diables you to use only the power button to power on the
system.
Resume by PCI-E PME
This system can be turned off with a software command. If you enable this
item, the system can automatically resume if there is an incoming call on the
PCI Express card. You must use an ATX power supply inorder to use this
feature. Use this item to do wake-up action if inserting the PCI Express card.
Power-On by Alarm
This item allows users to enable or disable the alarm to wake up the system. If set
to Enabled, users can specify the specific day of month and the exact time to
power up the system.
Hot Key Power ON
Use this item to allocate the hot key to wake up the system.
Power On After Power Fail
This item enables your computer to automatically restart or return to its last
operating status.
Press <Esc> to return to the main menu setting page.
To Next Page
Loading...
Need help?
General
