Chapter 3
BSWI-D2 USER MANUAL
37
+/- :Change Opt.
Enter : Select
F1:General Help
Aptio Setup Utility - Copyright (C) 2015 American Megatrends, Inc.
:Select Screen
:Select Item
F2:Previous Values
F3:Optimized Defaults
F4:Save & Exit
ESC:Exit
Version 2.17.1249. Copyright (C) 2015 American Megatrends, Inc.
Main Advanced Chipset M.I.B X Boot Security Exit
Parallel Port Configuration
Parallel Port [Enabled]
Device Settings IO=378h; IRQ=5;
Change Settings [Auto]
Device Mode [Standard Parallel...]
Enable or Disable Parallel
Port (LPT/LPTE)
Parallel Port Configuration
Scroll to this item and press <Enter> and view the following screen.
Parallel Port (Enabled)
This item allows you to enable or disable serial port.
Device Settings (IO=378h; IRQ=5)
This item shows the information of the device settings.
Change Settings (Auto)
Use this item to change device settings.
Device Mode (Standard Parallel...)
This item is used for Printer port mode selection, it can be set to Standard Parallel
Port Mode (SPP) or EPP Mode.
Press <Esc> to return to the Super IO Configuration page.
To Next Page
Loading...
Need help?
General
