ECS NF650iSLIT-A - Load Performance Defaults; Load Optinized Defaults

48
Using BIOS
Load Optimized Defaults
This option opens a dialog box that lets you install optimized defaults for all appro-
priate items in the Setup Utility. Press <Y> and then <Enter> to install the defaults.
Press <N> and then <Enter> to not install the defaults. The optimized defaults place
demands on the system that may be greater than the performance level of the
components, such as the CPU and the memory. You can cause fatal errors or insta-
bility if you install the optimized defaults when your hardware does not support
them. If you only want to install setup defaults for a specific option, select and
display that option, and then press <F7>.
User please remain the factory BIOS default setting of “Load Optimized
Defaults” When install Operation System onto your system.
Load Performance Defaults
If you select this item and press Enter a dialog box will appear. If you select [OK],
and then Enter, the Setup Utility loads a set of performance default values. These
default settings are quite demanding and your system might not function properly
if you are using slower CPU, memory, or other low-performance components.
Warning: To load Performance settings may make your system become
unstable or unbootable. When loading the Performance Defaults fails,
users can choose “either” step to return the motherboard to its defaults
BIOS:
1. Power on the system and press “Insert” key. The system will bypass the
previous BIOS setting and automatically reload the default BIOS. (This
procedure is BIOS setup only!)
2. Apply to the jumper setting reference onboard and proceed with the
“Clear CMOS” to recover the default BIOS setting. Please refer to Chapter
2, page 9, to complete the clear CMOS action. (This procedure requires
opening the chasis!)