Common faults
-------------------------------------------------------------------------------------------------------------------------------------------
1.Unable to start-up
Problem: After plugging in the power, turn on the power button. The indicator
light is not lighten up and the screen is not lighten up also.
Reason Inspection: this phenomenon usually means there is no power on
the whole machine, please check whether the power adapter light, if there
is no light, please check whether the city power socket is work is working or
not. If the power lamp is on, check that the power adapter is plugged into the
device.
Solution: replace the position of the power socket, and re-plug the connection
between the power adapter and the device to ensure that the plug is tight.
2.Screen owing, white screen, no display
Problem: After power on, the screen light up but display content is not
normal, such as white screen or display corruption.
Reason Inspection:This phenomenon is usually caused by unstable current
or electromagnetic interference around.
Solution: reboot the device's power. Make sure there are no large
electromagnetic sources around.
3.Temperature display alarm
Problem: after power on, Err:MAX MINTEMP PRINTER HALTED Please
reset
Reason Inspection: the thermistor in the Toolhead is damaged or not insert
the ToolHead Flat Cable
Solution: reboot the equipment and replug the Toolhead line to conrm this
phenomenon. If it is still the same after reboot, it indicates that the thermistor
has been damaged and needs to be replaced.
4.SD card contents cannot be read
Problem: After power on, the SD card cannot be read when the SD card is
inserted for printing.
Reason Inspection: Make sure the SD card is inserted in the right direction,
and then re-insert and unplug the SD card. If it cannot be displayed, re-format
it and insert it again. Please ensure that the SD card has a gcode le, the
name of which is in English.
Solution: Re-insert and unplug the SD card. If it still cannot be solved,
replace the SD card
5.The menu switch tool header function cannot be activated
Problem: After changing the Toolhead in the menu of the screen, it still not
change after rebooting the device.
Reason Inspection: When the Toolhead is selected from the menu, it will
take some time to change the rmware program within the system. It is
recommended to click "ok" at the last step and wait for more
than 5 seconds before reboot the device.
Solution: Do it again to ensure that the wait for validation is more than 5
seconds.
6.Cannot return to zero (X, Y, impact cannot return to zero, Z
cannot return to zero)
E
Common faults
--------
70
We have uploaded many common problems video tutorials on SD card and ofcial website.
If you have any problems, please read the tutorials rst and solve them. If you still can't
solve them, please contact us.
To Next Page
Loading...
