H10 Finger Oximeter User Manual
- 23 -
pulse rate (BPM) and provides a visual
indication of the pulse signal. The displayed
results of SpO
2
and PR are refreshed every
second. Stable measurement is obtained in
approximately 30 seconds. The values of
SpO
2
and pulse rate can be displayed
properly when pulse saturation is at 0.6%.
1. Insert two 1.5V AAA-size alkaline
batteries into battery tray. Follow the
polarity marks (+ and -) as illustrated.
Carefully guide the battery tray back
into the device.
2. Nip the clamp.
3. Insert one of your fingers; nail side up,
into clamp of the oximeter until the
fingertip touches the built-in stop
guide.
To Next Page
Loading...
