iSE Series Electrocardiograph User Manual System Setting
Report addition to an automatic ECG printout.
VCG (visible when activated. Settings are displayed according to the functions
activated.)
Record Time Choose from: 10s, 1 min, 3 min, 5 min.
Report Type Choose from: VCG Report, TVCG Report, SAECG Report.
X/Y/Z Wave Choose from: Off, On.
If On, print X, Y, and Z waves on the VCG report.
Analysis Choose from: Off, On.
If On, print the diagnosis on the VCG and SAECG report.
VCG Parameters Choose from: Off, On.
If On, print the detailed measurements on the VCG report.
QRS Gain Choose from: 10, 20, 40, and 80 mm/mV.
Change the gain of QRS loop, the gain of P loop and T loop will be
synchronized.
SAECG Filter Choose from: 25-250 Hz, 40-250 Hz.
VCG Analysis Choose from: X, Y, Z.
Display the real-time heart of the lead you choose on the recording
screen.
HRV Report (visible when activated)
RR Waveform Choose from: Off, On.
If On, print the compressed waveforms on the HRV report.
RR Interval List Choose from: Off, On.
If On, print the RR interval list on the HRV report.
Pharma Study Record Info (visible when activated)
Auto Save Choose from: Off, On.
If On, the system stores the ECGs recorded for the pharmaceutical
study.
Record Time Choose from: 0-1-3-5-10-15 (Minute), 0-1-3-5-7-9 (Minute),
0-2-4-6-8-10 (Minute), Customize.
This setting is related to the setting of report type below.
Report Type Choose from: All-Lead ECG Report, Single-Lead ECG Report.
If All-Lead ECG Report is selected, the system will print out a 9-lead
or 12-lead ECG report at the set N minute.
If Single-Lead ECG Report is selected, the system will acquire 10s
single-lead waveforms at the set N minute and at the end of
recording put all the acquired waveforms to a rhythm printout.
- 51 -
To Next Page
Loading...
