EDAN SE-12 Series - 10.3.2 Setup 2

SE-12 Series Electrocardiograph User Manual System Setup
- 52 -
WARNING
If the printer used is not the type listed above, additional safety measures (such as
applying an isolation transformer to supply the medical system) should be taken when the
safety of the medical system has not been evaluated. If in doubt, consult our technical
service department or your local distributor.
CAUTION
It is forbidden to connect or disconnect a U disk or a USB printer during the transmission
course.
NOTE:
1. During the USB printing course, pressing the PRINT/STOP key again cannot stop
printing ECG reports.
2. USB printing is ineffective in the auto periodic sampling mode, manual mode, VCG
mode, and R-R analysis mode.
10.3.2 Setup 2
Items
Default
Default (Only in the U.S.)
Measure / Analysis / Diagnosis
Conclusion / Report Confirm
On
On
Template / Position Marker /
Time Scale / Minnesota Code /
Device No.
Off
Off
Baseline Adjustment
Horizontal
Horizontal
RR Interval List
Off
Off
Grid of Thermal Report
Off
Off
Grid of USB Report
On
On