SE-12 Series Electrocardiograph User Manual Operation Instructions for Exercise ECG
- 69 -
c) Select, by using the Up/Down keys, the menu SYSTEM PARAMETER and press
Enter
d) Select, by using the Up/Down keys, the menu SETTINGS and press Enter
e) Select, by using the Up/Down keys, the menu RS232 PROTOCOL and press
Enter
f) Select, by using the Up/Down keys, ERGOLINE P4 and press Enter
g) Save the selected RS232 protocol or restore the default RS232 protocol, which is
also the LODE PROTOCOL.
h) Turn off the ergometer
4) For controlling the Lode ergometer by SE-12 Express
The ergometer should be set in the ANALOG mode. The ANALOG mode should be
selected as follows.
a) Turn on the ergometer and press Enter
b) You will be in MAINMENU
c) Select, by using the Up/Down keys, the menu SYSTEM PARAMETER and press
Enter
d) Select, by using the Up/Down keys, the menu SETTINGS and press Enter
e) Press Enter to confirm the menu DEFAULTSTARTMENU and press Enter
f) The Lode ergometer is now ready for external control
NOTE: You can also let the ergometer start up in the ANALOG mode every time
you turn on the ergometer, by using the default start menu.
If you turn off the ergometer, it will start up in the ANALOG mode every time the
ergometer is turned on again. For details on setting other models for external control,
please refer to the connection instruction of the models.
9. Select Patient on the main screen1 to open the Patient Information window, and then enter
the patient information. For details on entering patient information, please refer to Chapter 5,
"Entering Patient Information".
NOTE: If you do not enter the patient age or the birthday before pressing the Pretest key
to begin the exercise test, a hint will pop up to remind you to input the patient age.
11.3 Exercise Test
The following method is recommended when operating SE-12 Express electrocardiograph
connected with a treadmill.
To Next Page
Loading...
