EDAN SE-12 Series - Page 70

SE-12 Series Electrocardiograph User Manual Operation Instructions for Exercise ECG
- 64 -
3. If more than one fault occurs, only the hint information with a
higher priority will be displayed.
D
Hint Information2
Lead X Off, DEMO, Module Error, Overload, TM-400 Treadmill
hint information (including Lanyard Off, Transmission
Communication Error, Transducer Error, Incline Error, Great
Interference, No Speed Signal, Abnormal Speed, UART Error)
NOTE:
1. Lead X Off has a high priority to be displayed. The other hint
information of Hint Information2 has a normal priority to be
displayed.
2. If more than one fault occurs, the hint information which has
the same priority will be displayed in a circulative mode.
3. If more than one fault occurs, the hint information which has a
high priority will be displayed.
E
Current Protocol
The selected protocol name
F
Total Time
The total time counted from the beginning of the pretest phase to
the end of the exercise test.
G
Current Phase and
Stage
The current phase and stage of the exercise test
NOTE: Before or after the exercise test, state name is displayed.
H
Total Exercise Phase
Time and Stage Time
The left number is the total exercise phase time, which is counted
from the beginning to the end of the exercise phase.
The right number is the stage time, which shows the running time
of the current stage.
I
Current Speed or
Rotation Speed, Grade
or Power, Workload
When the treadmill is used, the current speed, grade and workload
of the treadmill will be displayed on the main screen; When the
ergometer is used, the current rotation speed and power of the
ergometer will be displayed on the main screen.
J
Current Time
Current examination time.
K
Battery Symbol
Identify the current capacity of the battery
L
Systolic Blood Pressure
and Diastolic Blood
Pressure
The left number is the systolic blood pressure, and the right
number is the diastolic blood pressure.
M
WIFI
If a wireless network is connected successfully, an icon appears on
the main screen.
: Poor signal (-85dBm ＜transmit power ≤-70dBm);