SE-12 Series Electrocardiograph User Manual FAQ
- 79 -
Q6: Memory Full is displayed on the main screen; Or, the hint Memory full! Replace the earliest
file? pops up every time when I save an ECG report to the electrocardiograph. What am I
supposed to do?
A6: Memory Full is used to remind you that the amount of stored file reaches the upper limit.
The display of the pop-up hint Memory full! Replace the earliest file? is related to the
settings of the File Setup window.
Select Off from the Replace When Memory Full list box, when the amount of stored files
reaches the upper limit and you save an ECG report to the electrocardiograph, the hint
Memory full! Replace the earliest file? pops up.
Select On from the Replace When Memory Full list box, when the amount of stored files
reaches the upper limit and you save an ECG report to the electrocardiograph, the hint
Memory full! Replace the earliest file? does not pop up.
You can deal with the hint as follows:
1) You can just delete several stored files from the electrocardiograph to ensure the amount
of stored file not to reach the upper limit.
2) When Memory Full is displayed on the main screen, you can set Auto Save to To U
Disk to save the added ECG reports. However, the amount of stored files in the
electrocardiograph still reaches the upper limit.
2. Printing Problems
Q1: I was encountered with paper-jam, what was I supposed to do?
A1: If it happened for the first time, it might be the result of an inappropriate placement of the
paper. In this case, please open the recorder casing, pull the paper out of the paper tray, tear
the pages with rumples, and then put the paper in the paper tray again, adjust the position of
the paper carefully and close the casing.
Q2: The hint Paper Error is displayed on the screen, what should I do?
A2: It might be the result of unsuccessful detection of the black markers, first open the recorder
casing so as to clear the error information, and then check whether the black marker is on the
bottom of the paper. Reload the paper in the paper tray. If it doesn't work, change the paper.
If the problem still exists, please contact the manufacturer or the local distributor for further
disposal.
Q3: The hint No Paper is displayed on the screen, what should I do?
A3: Check whether the paper runs out, or the black marker is just facing the black marker
detection window on the thermal printing head, as the following figure shows.
To Next Page
Loading...
