SE-12 Series Electrocardiograph User ManualManaging Orders
Chapter 8 Managing Orders
NOTE: To use the order function, the ECG data management software (DMS) of
EDAN must be installed in the PC.
Operation procedures are as follows:
1. On the electrocardiograph, configure the Order Setup screen.
2. Connect the electrocardiograph to the PC installed with the DMS by using an Ethernet cable
recommended by the manufacturer.
3. Set Server IP, Local IP, Gateway and Subnet Mask in the Transmission Setup window. For
details, please refer to Section 10.5 "Transmission Setup".
4. Select Load on the Order Manager screen to load orders from the DMS, and then a hint will
be displayed as follows.
NOTE: If orders are modified on the DMS, the corresponding orders displayed
on the Order Manager screen will be refreshed after you load orders
from the software.
A
B
IHGFEDC
Figure 8-1 Order Manager Screen
- 43 -
To Next Page
Loading...
