EDAN SE-1200 Express - Basic Setup

SE-12 Series Electrocardiograph User ManualSystem Setup
10.5.1 Basic Setup
Item
Description
IP Addresses
Set Server IP, Local IP, Gateway, Subnet Mask
For the cross-network transmission,
a)
Set the first two sections of the Local IP item to the first two sections
of the IP of the PC.
b)
Set the third section of the Local IP item to the network segment of
the electrocardiograph which depends on the configuration of Router.
c)
The last section of the Local IP item can be set at random.
For the same network transmission,
a)
Set the first three sections of the Local IP item to the first three
sections of the IP of the PC.
b)
The last section of the Local IP item can be set at random, but it can't
be the same as the last section of the IP of the PC.
NOTE: If WIFI is enabled and Auto Get IP is selected in the WIFI
Setup window, IP addresses excluding server IP can be
acquired automatically.
10.5.2 WIFI Setup (Configurable)
NOTE:
1. The WIFI transmission function is only available for the machine configured with the
WIFI module.
2. Data transmission through Wi-Fi is not supported during ECG sampling.
Item
Description
Auto Get IP
Select this item, addresses of Local IP, Gateway and Subnet Mask will be
acquired automatically after the wireless network is connected successfully.
NOTE:
1.
Only if WIFI is disabled, can Auto Get IP option be available.
2.
To use Auto Get IP, DHCP function needs to be enabled on the router.
View MAC
View the MAC address of the WIFI module.
Address
- 53 -