SE-12 Series Electrocardiograph User ManualOperation Preparations
NOTE:
1. When turning off the device, follow the above sequence strictly, or else there may be
something wrong on the screen.
2. Do not hold down the key when the device displays the hint information System is
shutting down… on the screen.
3.6 Loading Recorder Paper
NOTE:
1. When the folded thermal paper is used, the paper roller is unnecessary and must be
taken out.
2. When using the paper of 215mm in width, the two movable parts should be removed.
3. The exit edge can help you tear the recorder paper.
4. If the paper with black markers is used, make sure that the markers are on the bottom.
CAUTION
Make sure that the recorder paper, is installed in the center of the recorder, and the
paper edge is parallel with the casing edge in the direction of advancing paper, in order
to avoid paper deviation or damage to the paper edge.
When the recorder paper runs out or is not loaded, the hint message No Paper will appear on the
screen. Then you should load or replace the recorder paper immediately.
To Next Page
Loading...
