SE-12 Series Electrocardiograph User Manual
U Disk / USB Printer / USB
A U disk, a USB printer or a bar code reader / security reader / ID
card reader is connected to the USB interface.
Table 12-2 Hint Information and Causes for Exercise ECG
Recorder paper runs out or is not loaded.
When Paper Marker is set to Yes, the electrocardiograph
advances the recorder paper to the next black
advances the paper for 300mm and cannot find the next black
marker, the hint Paper Error is displayed.
There is something wrong with the signal sample module.
The system is in the demonstration mode.
Electrodes fall off the patient or the patient cable falls off the unit.
The direct current offset voltage on an electrode is too high.
Heart rate exceeds the normal range.
Systolic blood pressure exceeds the normal range.
Diastolic blood pressure exceeds the normal range.
The safety stop (mushroom type) is revolved and the safety stop
(cord type) is pulled out.
The transducer and the main control board lines are not connected
The transducer doesn't work well or is not connected well.
The incline motor doesn't work well or is not connected well.
There is great magnetic interference around the transducer.
The speed sensor doesn't work well or is not connected well.
To Next Page
Loading...
