EDAN SE-3 Series - Transmission Setup

SE-3&SE-300 Series Electrocardiograph User Manual Settings
- 54 -
Select Age Group, the Age Group textbox appears in the Patient
Information window.
PatInfo Refreshed
Choose from: On or Off, the default value is On
Select On, the patient information will be refreshed after the ECG report
is printed out and all the leads are off.
H/W Unit
Choose from: cm/kg or inch/lb, the default value is cm/kg
BP Unit
Choose from: mmHg or kPa, the default value is mmHg
8.5 Transmission Setup
NOTE:
1. To transmit ECG data to the PC in DAT format, the Smart ECG Viewer software
produced by the manufacturer must be installed in the PC. You should log into the
Smart ECG Viewer software before transmission.
2. To transmit ECG data to the PC in DICOM/SCP/FDA-XML/PDF format, the FTP
receiving software must be installed in the PC. You should log into the FTP receiving
software before transmission.
Item
Description
Device No.
Enter Device No., it should be within 7 ASCII characters.
Auto Transmission
Choose from: On or Off, the default value is Off
Select On, ECG data will be transmitted automatically after an ECG
report is printed out in the auto or rhythm mode; in the off mode, 10s
ECG data sampled before pressing the PRINT/STOP key can be
saved and transmitted, but cannot be printed.