Edge-Core ES3526S - User Manual

Questions and Answers:

D
Diamond CookJul 31, 2025
What to do if the Link/Act port indicator is off on Edge-Core ES3526S Network Hardware?
- J
  Jessica MarshallJul 31, 2025
  If the Link/Act port indicator is off on your Edge-Core Network Hardware, it means there is no valid link on the port. Here's what to check: * Make sure both the switch and the connected device are powered on. * Ensure the cable is properly connected to both the switch and the device. * Confirm you're using the correct cable type and that it's not too long. * Inspect the port on the connected device and the cable connections for any damage. If you find any, replace the faulty device or cable.
N
Nathaniel StuartAug 5, 2025
How to troubleshoot Edge-Core ES3526S Network Hardware when the power indicator is off?
- J
  Jason HardinAug 5, 2025
  If the power indicator is off on your Edge-Core Network Hardware, it indicates that AC power is disconnected or the internal power supply may have failed. First, check the AC connections between the switch, the power cord, and the wall outlet. If the problem continues, the internal power supply might have failed, and you should contact your local dealer for assistance.
M
melissaharperAug 10, 2025
What does it mean when the Remote Error indicator is flashing green on Edge-Core ES3526S Network Hardware?
- A
  andreyangAug 10, 2025
  If the Remote Error indicator on your Edge-Core Network Hardware is flashing green, it means that the CPE media converter’s power is off or has failed. Check the AC power adapter connections between the CPE and the wall outlet. If that doesn't solve the issue, the AC power adapter may have failed, so replace it. If the problem persists, the CPE’s internal power supply may have failed, and you should replace the defective CPE.
B
bartoneduardoAug 15, 2025
What to do if Diag indicator is on amber on Edge-Core ES3526S Network Hardware?
- S
  Scott LeeAug 15, 2025
  If the Diag indicator is amber on your Edge-Core Network Hardware, it means the system diagnostic test has detected a fault. Try restarting the switch to clear the condition. If the condition persists, contact your local dealer for assistance.
M
Michele PerryAug 20, 2025
Why is the Remote Error indicator on amber on my Edge-Core ES3526S?
- D
  Diamond HamiltonAug 20, 2025
  If the Remote Error indicator is amber on your Edge-Core Network Hardware, it indicates that the CPE media converter’s fiber port is disconnected. Make sure the fiber cable is correctly connected to the media converter device. Also, check the cable connections for any defects and replace the defective device or cable if necessary.
C
Chelsea FisherAug 26, 2025
What does it mean when the power indicator is on amber on Edge-Core ES3526S?
- C
  Carolyn PriceAug 26, 2025
  If the power indicator is on amber on your Edge-Core Network Hardware, it means that the internal power supply has a fault. Contact your local dealer for assistance.

Edge-Core ES3526S Specifications

General

Model	ES3526S
Jumbo Frame Support	9KB
Power over Ethernet (PoE)	No
Console Port	1 x RJ-45
VLAN Support	Yes, 4K VLANs
Management	Web GUI, CLI, SNMP
Operating Temperature	0°C to 50°C
Power Supply	100-240 VAC, 50/60 Hz