Mounting
3-3
3
Figure 3-2 Installing the Switch in a Rack
3. If installing a single switch only, turn to “Connecting to a Power Source” at the
end of this chapter.
4. If installing multiple switches, mount them in the rack, one below the other, in
any order.
Desktop or Shelf Mounting
1. Attach the four adhesive feet to the bottom of the first switch.
Figure 3-3 Attaching the Adhesive Feet
2. Set the device on a flat surface near an AC power source, making sure there
are at least two inches of space on all sides for proper air flow.
26
Link/Act
PoE
25
26
PWR
Diag
Stacking
Mode
PoE/Link
25
ES3526S
ES3526S
To Next Page
Loading...
Need help?
General