Edge Products CS - Page 9

U S E R G U I D E
I N T R O D U C T I O N
INTRODUCTION PARTS DESCRIPTION INSTALLATION OPERATING INSTRUCTIONS INTERNET UPDATES APPENDIX
9
U S E R G U I D E
Programming your vehicle may expose existing defects in your
vehicle’s PCM that could disable your vehicle. It is advised that
you do not program your vehicle in remote locations in case of
vehicle failure.
CAUTION: The Evolution employs carefully modied strategies that are de-
signed to be utilized on unmodied (stock) vehicles only.
Many aftermarket components such as cold air intake (CAI) kits, exhaust
systems, and throttle body spacers as well as forced induction systems (turbo-
chargers, superchargers, nitrous oxide, etc) alter the calculated airow charac-
teristics of the engine. In addition, mechanical modications to the engine such
as displacement changes, camshaft modication, and cylinder head modication
may alter calculated airow characteristics.
Using any of these modications (either alone or in any combination) in
conjunction with the Evolution is NOT RECOMMENDED as it may cause an
excessively lean condition which could result in engine damage.
Edge Products will not be responsible for any damages caused by using the Evo-
lution on a vehicle that has been modied from a stock conguration.
If you have used another tuner/programmer on your vehicle, you will need
to program back to stock and remove the device before using the Edge Products
Device.
Failure to return to stock may result in PCM failure or engine damage.