Edge Technologies V-65 Series - 2. DATA OF TECHNIQUE; 2.1 Bar Feeder Introduction

2. DATA OF TECHNIQUE V-65E-A
2-1
2. DATA OF TECHNIQUE
2.1 Introduction of the bar feeder
The V-65E/LE-A is designed for full automatic lathe to auto feeds material, the bar
feeder is suitable for digital control sliding headstock lathe and fixed headstock
lathe. The program of the P.L.C system can control the bar feeder running with the
lathe at the same time. Operator can set parameters by the interface of man
machine directly.
The remote control box is easily to be operated.
The bar feeder can feed circular material and any other forms of material. While
the lathe is running, the guide channel is closed completely; meanwhile, the
lubricating oil is poured into the guide channel. Therefore, noise and shake can be
reduced while the material is rotated in high speed.
Furthermore, the lubricating oil also can reduce the temperature resulted from
friction so the surface of material can't be damaged. The remnant material will be
pushed out off the guide channel by the push bar or the next material.
The instructions and legends of the manual are edited according to the operator
stands at the left side of the lathe.