6. OPERATIONS AND ILLUSTRATIONS V-65E-A
6-23
6.4 Refer alarm message
6.4.1 HMI Alarm Message
ERROR / CAUSE CURE
※ Please check the value of long feed safety is correct
※ Check the turret whether at correct position of stopping
material
※ Please check the value of short feed safety is correct
※ Check the turret whether at correct position of stopping
material.
※ Check compressed air whether enough.
※ Pull out the tube of the combination unit and then insert the
tube again.
※ Check compressed air whether enough.
※ Pull out the tube of the combination unit and then insert the
tube again.
※ Please refer to electrical diagram (P.01), check SR3 andSR4
whether have foreign metals adhere to them.
※ Please refer to electrical diagram (P.01), check LS2 whether
be jammed by any foreign object.
※ Please refer to electrical diagram (P.01) , check LS1
whether be jammed by any foreign object.
※ Please refer to electrical dia
gram (P.01), LS3 and LS4 are
operative while SS1 is opened.
※ Please close the covers.
To Next Page
Loading...
