6. OPERATIONS AND ILLUSTRATIONS V-65E-A
6-22
Parameter description︰This parameter allow technician to test each signal
output on interface is continued to lathe.
Setting method︰ To executive this parameter must be under manual
mode both lathe and bar feeder or could cause
danger.
Home page
1.2M Generally value：
Setting range ：
NO
1.5M Generally value：
Setting value ：
Parameter description︰+Z point (It has been set up in the factory.)
(1) It is the last position for loading.
(2) To send the feeding bar to the last position at a
time from the secondary position, at this moment,
the present digit minus 5 that is the +Z point value.
Home page
1.2M Generally value：
Setting range ：
1200~1700
1.5M Generally value：
Setting value ：
To Next Page
Loading...
