How to fix Edge CS Touchscreen EGTs not displaying?
If the Edge EGTs are not displaying, the connector on the back of the device might not be fully seated. Ensure the cable connection is not upside down, and push the cable until it is fully seated.
What to do if I get Error 16 when programming my Edge CS Touchscreen?
If you receive Error 16 during programming, it indicates a communication error. The suggested solution is to try programming the level again.
What to do if my vehicle does not start after programming my Edge CS?
If your vehicle doesn't start after programming, the calibration may not have written correctly. Select “Return to stock” from the programming menu and try to start the vehicle again.
Why does my Edge CS beep quickly?
A series of quick beeps from your Edge Touchscreen indicates a possible device malfunction. To resolve this, update the device using the fusion software.
Why does my Edge Touchscreen beep for two seconds and have no display?
If the screen beeps for two seconds (long beep) and there is no display when the key is in the “on” position, the unit may be too hot from being in direct sunlight. Once the device cools down, the screen will turn itself on. You can also touch the screen or start the vehicle with the key in the “on” position until the screen is touched or any button is pressed.
What to do if my Edge CS camera picture is frozen?
If the camera picture is frozen on your Edge Touchscreen, this is caused by bad connections. Cycle the key off and on to attempt to fix this.
What to do if Fusion drivers will not install correctly for my Edge Touchscreen?
If the Fusion drivers do not install correctly, it means that the drivers were not successfully installed by the automatic installer. Manually install the drivers.
Lists supplied items (device, mount, cables, CD, etc.) and suggested tools.
Guides users on finding the OBDII port under the dashboard.
Details how to route the OBDII cable from the port to the dash.
Explains how to position the device on the windshield and clean the area.
Instructs on attaching the mount to the device and connecting the OBDII cable.
Guides on locking the mount to the windshield and adjusting viewing angles.
Advises checking device placement for visibility and compliance with local laws.
Explains how to navigate the device's menu system using buttons or touch.
Explains the alert system, how alerts are indicated, and the alerts screen.
Explains how to choose and program power levels for the vehicle.
Details the different power levels (Economy, Towing, Performance, Extreme) and their uses.
Explains how to create custom programs and adjust parameters like tire size and speed limiter.
Introduces the diagnostics menu and its sub-options (Trouble Codes, Manual Regen, Performance Tests, Records, Injector Balance Rates).
How to retrieve and clear trouble codes (DTCs) from the vehicle's PCM.
Step-by-step guide to retrieve and view Diagnostic Trouble Codes (DTCs).
Instructions on clearing Diagnostic Trouble Codes (DTCs) and when to seek professional help.
Explains Diesel Particulate Filter (DPF) regeneration, passive and active methods.
Guides on performing a manual regeneration cycle and safety precautions.
Explains how to identify faulty injectors using balance rates and diagnostic criteria.
Explains how to turn alerts on/off and set alert values for various parameters.
Details how to enable/disable specific alerts and adjust set points.
How to re-calibrate the speedometer for non-stock tire sizes.
Guides on inputting tire size using P-Metric or English formats.
How to reset all device settings back to factory defaults.
Guides on installing and using Fusion software for device updates.
Details the steps for updating the device via Fusion software and device information display.
Provides common troubleshooting tips and solutions for device issues.
General| Brand | Edge |
|---|---|
| Model | CS |
| Category | Touchscreen |
| Language | English |
To Next Page