EdgeStar AP8000W - Remote Control Overview

Portable Air Conditioner 12
Remote Control Overview
The remote control is used to operate all of your portable air conditioner’s
functions.
Installing the batteries
POWER
Mode Button
Up and Down
Buttons
Power Button
Speed Button
Timer Button
Cancel Button
Celsius /
Fahrenheit Button
CAUTION: Use only AAA batteries. Remove the batteries if the remote control will not be used for one month or longer.
Do not attempt to recharge batteries not designed to be recharged. All batteries should be replaced at the same time.
Do not mix old and new batteries. Do not dispose of batteries in a fire as they may explode.
Button
Function
Power
Powers the unit on or off.
Mode
Changes between cool, dehumidify and fan modes.
Speed
Sets the fan speed between high, medium, or low.
Timer
Used to enable the timer.
Cancel
Used to cancel the timer.
Up
Increases the set temperature or the time when the
Timer is enabled.
Down
Decreases the set temperature or time when the Timer is
enabled.
ºC / ºF
Changes the displayed temperature between Celsius
and Fahrenheit.
NOTE: Be careful not drop
the remote control. Do
not place the remote
control in a location
exposed to direct sunlight.
1) Remove the cover on the back of the remote control.
2) Insert the batteries with the (+) and (-) ends pointing in the
correct direction.
3) Install the cover on the remote.