Portable Air Conditioner 16
Maintenance
Clean the air conditioner and filters regularly to maximize performance
and efficiency, and prolong the unit’s life. Be sure to always unplug the air
conditioner from the power outlet before cleaning.
Use a soft dry cloth to wipe the body clean. If necessary, use lukewarm
water to dampen a cloth to clean the unit.
Use a soft bristle brush to clean between the vents.
Carefully use a vacuum cleaner to clean the condenser coils.
Never use abrasive chemicals, volatile substances, gasoline, detergents,
chemically treated cloths, or other cleaning solvents that may damage
the cabinet exterior.
Never spray water directly on the unit.
To clean the pre-filter, follow the steps below:
1) Power off the unit and remove the pre-filter.
2) Remove the activated carbon filter.
3) Use a vacuum cleaner or tap the filter lightly to remove loose dust and
dirt, then rinse thoroughly under lukewarm running water (below 104°F).
You may use a mild soap and water solution if needed. Allow the pre-filter
to air dry in a cool and shaded place. Dry thoroughly before reinstalling.
Clean the pre-filter periodically. If the unit is used in a dusty environment
you may need to clean it on a weekly basis.
Warning: Never operate the unit without the pre-filter.
If you are not going to be using the unit for an extended period of time,
follow the instructions below before storing your unit:
1) Drain all the water from the unit’s reservoir. Operate the unit in fan
mode for a few hours to thoroughly dry any moisture left on the coils inside
the unit.
2) Power off the unit, and clean or change the filters.
3) Unplug and carefully wind the power cord.
4) Remove the exhaust hose and duct connectors and keep them in a
safe place.
NOTE: The activated carbon
filter is not washable. You
should replace it every 2-3
months or as needed.
Contact EdgeStar retailers for
replacement filters.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
