EdgeStar Dishwasher 6
8. Slowly open the hot water line and c
connections. If leaks are located, imm
heck for any sign of water leaks at all
ediately close the water supply and
repair the hose connections.
plied, then the following procedures should be followed:
er) to your faucet.
If your existing faucet adapter is not compatible with the “quick connect” hose
assembly sup
• Connect the faucet adapter (included with dishwash
aded) connection, both rubber
faucet adapter.
ed) connection, use only the
standard rubber washer (0.2”/5mm thick) sup lied within the adapter. Remove
the second rubber washer.
rge
out
nd replaced with clean water at the end of each cycle (the number of times this
repeated depends on the wash cycle chosen).
formance of your
e’ (white film
stainless steel surface of the
ted in the sump underneath the
t in minimizing these conditions, it is
inside of the dishwasher (empty)
isconnecting your Dishwasher
1. Close the hot water supply at the faucet.
power supply cord.
release the water pressure inside the inlet hose.
re relief button on the
s.
. Disconnect the quick-connect hose assembly by pulling down on the outer
locking collar, thus releasing it from the faucet adapter.
• Failure to relieve water pressure before disconnecting the Quick
Connect assembly from the Faucet Adapter may result in backpressure
overspray.
• The inlet water temperature can be EXTREMELY HOT!
• Backpressure overspray could cause SEVERE BURNS and/or
SCALDING!
• If your faucet is inclusive of a ‘female’ type (thre
washers must be installed inside the
If your faucet is inclusive of a ‘male’ type (thread•
p
For Best Results:
our dishwasher cleans by spraying m n hot water and dete
nder pressure) against the soiled surfaces of dishes. The water is
rough a rotating spray arm, drained through a filter (removing food and soiled
articles) and pumped back through the spray arm. Soiled water is pumpe
Y nt a ixture of clea
(u pumped
th
p
a
d
is
NOTE:
Hard water conditions will adversely affect the washing per
contribute to ‘limdishwasher. Hard water conditions will also
he substance) deposits and/or ‘scaling’ on t
dishwasher tub and heater element, loca
removable filter screen. To assis
recommended to periodically operate/rinse the
using 1 cup of white vinegar at least once a week.
D
2. Disconnect the
3. Remember to
4. The inlet hose is pressured when the water supply line is opened, even if
closed immediately.
5. To release pressure: press and hold the red pressu
quick-connect assembly until the flow of water stop
6
To Next Page
Loading...
