Preparing the Dishwasher for Use
er has been designed for a countertop installation. Please follow
e instructions for clearance, water and electrical requirements.
t connection is within reach of the inlet and
plugged.
5ºC (130ºF). To prevent
er, the temperature of the incoming water supply should
a switch or
ectrical
ng
st be plugged
nding-type wall receptacle providing 110-120V,
ith the National Electrical Code and local codes
nd ordinances. If a mating wall receptacle is not available, it is the personal
e.
Unpacking the Dishwasher
Use at least two people to move and install the dishwasher to prevent back and
other types of injuries. Carefully remove the packaging materials. Remove any
shipping tape and glue from your dishwasher before using. Do not use sharp
instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove
tape or glue. These products can damage the surface of your dishwasher. Check
to make sure the parts necessary for installation are included. If any parts are
missing, please contact our customer service. Put the dishwasher on a level and
flat surface that is able to support the entire weight of the dishwasher fully
loaded.
Installation Requirements
The dishwash
th
Clearance Requirements
The minimum height clearance required to install your dishwasher on a counter
top surface with overhead cupboards is 45cm (17.7”).
Water Requirements
Make sure the water supply/fauce
drain hose assembly (i.e., 58 cm / 22.8”). If your sink has a spray wand, it is
recommended that the hose be disconnected and the hole
WARNING: A hose that
attaches to a spray wand can
burst if it is installed on the
same water line as the
dishwasher.
Water Pressure
For best results, incoming water pressure should be between 15 and 20 pounds
per square inch (psi).
Water Temperature
For best results, the water temperature must be at least 5
damage to the dishwash
not exceed 65ºC (149ºF).
Electrical Requirements
Read all safety precautions listed at
recommended that you use recepta
pull chain.
Make sure there is an elec
power supply cord (195 cm / 6.3 ft).
The dishwasher is equipped with a po
grounding plug. To minimize possibl
into a mating 3-pronged and grou
0Hz, grounded in accordance
the beginning of this manual. It is
cles that cannot be turned off by
trical supply (outlet) within reach of the el
wer supply cord having a 3-pro
e shock hazard, the cord mu
WARNING! Do not, under any
circumstances, cut or remove
the third (ground) prong from
the power cord.
6 w
a
responsibility of the customer to have a properly grounded, 3-prong wall
receptacle installed by a certified electrician. Use a circuit that is rated for 10
amps.
WARNING: Do not use an extension cord or an adapter plug with this applianc
EdgeStar Dishwasher 4
To Next Page
Loading...
