Starting the Wash Cycle
• Ensure that the unit is connected to the power supply.
• Ensure that the water supply is turned on to full pressure .
• Pour in the detergent
• Press the ON/OFF switch to power the dishwasher on.
• Rotate the knob to the desired cycle. The wash cycle will be
changed as following direction:
Heavy -> Normal -> Light -> Glass -> Speed -> Soak
• Press the START/PAUSE button, the dishwasher begins to start.
will stop blinking. Unless the
button is pressed to continue the cycle, an indicator beep
Once the dishwasher is fully loaded follow these procedures to start the
wash cycle:
NOTE:
When the START/PAUSE button is pressed during a wash cycle the cycle
is suspended and the program light
START/PAUSE
will be heard every minute.
Changing the Cycle
ing cycle, but only when the dishwasher has
ressing the START/PAUSE button for three seconds or more will put the
achine in a stand-by state. At this point the cycle setting can be
You can modify the wash
been running for a short time. Otherwise, detergent may have been
release, and the appliance may have already drained water. If this is the
case, the detergent dispenser must be refilled.
Opening the door during the wash cycle may result in injury from
calding hot water. s
P
m
changed.
NOTE:
If the door is opened during the wash cycle, the machine will be paused.
When the door is closed, the machine will restart in 10 seconds.
EdgeStar Dishwasher 14
To Next Page
Loading...
