Edgetech 3200-XS - Reassembling the Tow Vehicle; Figure 4-6: Teardrop Cover Removed; Figure 4-7: Removing 7;16 and 1;2-Inch Bolts and Nuts Securing the Top Cover of the Tow Vehicle Body

4-6 SECTION 4: Maintenance and Troubleshooting
3200-XS Sub-Bottom Profiling System User’s Manual Doc. No. 990-0000026-1000, Rev. 2.3
5. Disconnect the spider cable
from the components
shown in Figure 4-6.
6. Using the socket wrench
with the 7/16-inch socket,
remove all of the bolts and
nuts securing the front half
of the top cover of the tow
vehicle body as shown in
Figure 4-7. Continue with
the rear half using a
1/2-inch socket.
7. Lift the top cover off, turn it
over and disconnect the
spider cable from the
hydrophones and the
preamp components.
4.3.2 Reassembling
the Tow Vehicle
To reassemble the tow vehicle reverse the disassembly procedure described in
“Disassembling a Tow Vehicle” on page 4-3.
Figure 4-6: Teardrop Cover Removed
Spider cable
Figure 4-7: Removing 7/16 and 1/2-Inch Bolts and
Nuts Securing the Top Cover of the Tow Vehicle Body
7/16-inch bolt
(1/2-inch bolts in rear half)