EasyManuals Logo

Edgewater Networks 268CC User Manual

Default Icon
196 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
18
7/Drainage System
7.1 General
All water drains from your EdgeWater 268CC by gravity. Your boat is self-bailing at rest. It is
important to check drains frequently to make sure they are clear and free flowing. Review the
schematic in the Appendix and become familiar with the location of each thru-hull drain.
7.2 Drain System Maintenance
Essential tasks must be done periodically to maintain your boat’s ability to drain in adverse
conditions.
Clean cockpit drains to remove debris or other foreign objects that could prevent boat from
draining properly.
Check bilge areas, aft and console, for debris and foreign material, which can cause automatic
switches to malfunction.
Flush drains to keep free flowing and clean.
7.3 Cockpit Drains
Your EdgeWater 268CC drains aft through four cockpit drains located at the aft deck area. The
deck is designed to take water and drain it overboard. The drains should be checked
periodically to
make sure they are clear running and free from debris. When washing the boat down after use,
use a hose nozzle with a high-pressure stream to make sure they are free running.
7.4 Transom Bilge
Your EdgeWater 268CC has a hull bilge where the raw water pump and automatic bilge pump are
located. The bilge pump is designed with an internal float so that it automatically turns on if the
water in the sump rises, or it may also be activated by a momentary switch on the panel. This
pump should be periodically checked to make sure it is working properly and that the drain screen
is clear. To check the pump, squeeze the pump sides and lift it from the base, which is fastened to
the hull. The screen will be easily seen and if there is debris, it may be cleaned and replaced.
Replace the pump assembly and check its operation by turning on the momentary switch on the
helm switch panel.
When the boat is out of the water it may be drained by a thru hull drain located at the bottom of
the transom. This drain has a brass plug that may be removed with a ½” wrench. This plug should
be periodically checked for tightness.
Note: The bilge sump area should be checked for oil before operating the bilge pump. The
discharge of oil from a bilge area is illegal and is subject to a fine. The Federal Water
Pollution Control Act prohibits the discharge of oil or oily waste into or upon the navigable
waters of the United States or the waters of the contiguous zone if such discharge causes a film or sheen
upon, or a discoloration of the surface of the water, or causes a sludge or emulsion beneath the surface
of the water. Violators are subject to a penalty of $10,000.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Edgewater Networks 268CC and is the answer not in the manual?

Edgewater Networks 268CC Specifications

General IconGeneral
BrandEdgewater Networks
Model268CC
CategoryBoat
LanguageEnglish

Related product manuals