Edgewater Networks 268CC - Design Features

6
Original instructions
> English
Security
t 5IFQVNQNBZOPUCFVTFEGPSPUIFS 
liquids than water/bilge water.
t "MXBZTJOTUBMMUIFQVNQBDDPSEJOHUPUIF
wiring diagram, see page 16-18.
t "MXBZTVTFUIFGVTFSFRVJSFETFF 
”Design features” below.
t 5IFXJSFDPOOFDUJPOTNVTUCFTFBMFEXJUI
a marine sealant.
t *OTVMBUJPOPSDBCMFTIFBUIJOHTNVTUCF 
placed above the highest bilge water level.
t %POPUSVOESZ
Installation
Please follow the installation instructions carefully to assure maximum efficiency in your bilge
pump operation.
1. Remove the strainer from the bottom of the pump by depressing the lock tabs on both
sides of the pump.
2. Determine the desired location for the pump. Usually it is placed in the lowest point of
the bilge.
Design features
L1600 L2200 L4000
Hose size: 1¹⁄
8" 1¹⁄8" or 1½" 1½"or 2"
Capacity, straight
(13,6V/27V): 100 l/min/(1 600 GPH) 130 l/min/(2 060 GPH) 258 l/min/(4 100 GPH)
(12V/24V): 92 l/min/(1 450 GPH) 120 l/min/(1 900 GPH) 252 l/min/(4 000 GPH)
Capacity, 1m head
(13,6V/27V): 98 l/min/(1 550 GPH) 120 l/min/(1 900 GPH) 196 l/min/(3 100 GPH)
(12V/24V): 88 l/min/(1 400 GPH) 110 l/min/(1 750 GPH) 164 l/min/(2 600 GPH
Voltage: 12/24 V DC 12/24 V DC 12/24 V DC
Amperage: 12V – 7A 12V – 7.5A 12V – 19,5A
24V – 3,5A 24V – 4,5A 24V – 10A
Fuse size: 12V – 10A 12V – 12A 12V – 25A
24V – 6A 24V – 6A 24V – 15A
Body: Thermoplastic Thermoplastic Thermoplastic
Shaft: SS2343 SS2343 SS2343
Shaft seal: Lip seal Mechanical seal, Mechanical seal,
carbon/ceramic carbon/ceramic
Wire size: 1,5mm
2
1,5mm
2
14 Gage
Max height: 149mm 177mm 216mm
Max dia: 108mm 108mm 121mm
Weight: 1,3 kg 2,25 kg 2,45kg
Submersible bilge pump L1600, L2200 and L4000, 12/24 V
Submersible bilge pump for pumping bilge water in marine environment. To be installed in the keelson.
Type designation
Pumptype Part nr
L1600 12 V 32-1600-01
L1600 24 V 32-1600-02
L2200 12 V 32-2200-01
L2200 24 V 32-2200-02
L4000 12 V 32-4000-01
L4000 24 V 32-4000-02