EasyManuals Logo

Edgewater Networks 268CC User Manual

Default Icon
196 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #26 background imageLoading...
Page #26 background image
25
Perform docking at idle or no wake speeds. Always try to come into wind or current, whichever is
stronger. This allows you to use the natural forces on your boat to act as a natural brake. The
skipper is free to use the boat’s power to control speed and direction.
The approach to the dock should be at roughly a 45
o
angle, when possible. This approach angle
allows the captain to bring the bow close to the dock, and then to use reverse, while turning the
wheel toward the dock, to bring the boat to a safe, controlled stop.
Never approach a dock on plane. Even after reducing engine speed, the wake will push the boat
uncontrollably into the dock.
9.7 After Operation
Refill the fuel tank and engine oil, if yours is a two-cycle engine. A full fuel tank is less subject
to condensation and therefore, less fuel problems. If you will be leaving the boat for an
extended period, use a good fuel stabilizer. Each engine manufacturer makes their own
and
proper
use will avoid many fuel related and lay-up problems. Remember; always follow the
manufacturer’s recommendation.
If t
he boat is to be left in the water, make sure it is secure and free to properly
accommodate any tide.
Turn off all electronics and leave the battery switch in the off position. Remember, the
bilge pump will operate properly even with the battery switches turned off. On a comforting note,
your EdgeWater 268CC is fully self-bailing and unsinkable. Proper precautions, however, are
always prudent.
9.8 Trailering Your Boat
Note: If you have doubts or questions about your tow vehicle or towing, contact your
dealer.
Before going on the highway, make sure your tow vehicle and trailer meet the local
regulations for trailers and towing in your state.
Before leaving the driveway make sure the lights on the trailer are operating properly. If
necessary, get a second person to make sure of the operation.
At least once a season, check and repair/replace the trailer wheel bearings.
The trailer should be adequately sized for your boat. Allow about 10%
above the maximum boat weight for trailer capacity.
Tow
vehicle
Trailer
Make sure your vehicle is properly equipped to handle the load. This includes engine,
hitch, frame, brakes, transmission cooler, and vehicle capacity.
Bottom View of
Crossed Trailer
Chains
Securely attached the boat trailer to the vehicle hitch, hook the safety chains and cross them
under the hitch and check the lights to ensure they are hooked up and working.
If you are new to trailering your boat, it is best to practice before actually getting in a situation
where you are not sure of your ability. If possible use a trailer without a boat to practice with as

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Edgewater Networks 268CC and is the answer not in the manual?

Edgewater Networks 268CC Specifications

General IconGeneral
BrandEdgewater Networks
Model268CC
CategoryBoat
LanguageEnglish

Related product manuals