23
2.2.2 Guard Tour
You can make the camera move between many pre-defined positions, and define the time you wish to pause
at every position; this is called as ‘Guard Tour’.
Before you can use this function, you have to define at least 2 positions in ‘Preset Points’ section (refer to last
section for detailed information).
The descriptions of every setting in this menu will be given below:
Add a new set of guard tour (see instructions below)
Edit
Edit a selected guard tour. The parameters for an existing guard tour will be
recalled and you can modify them.
Start / Stop
Select a guard tour and click this button to start grand tour, click again to stop it.
After a guard
tour has been started, go to ‘Camera’ menu to see it in action. Only
one guard tour can be activated at the same time.
Remove a guard tour from the list.
If you wish to add a new set of guard tour, click ‘Add’ to start to add a new guard tour set:
To Next Page
