27
II-3. WPS (Wi-Fi Protected Setup)
The WPS button is a quick and easy alternative to establish a secure wireless
connection between your network camera and your wireless router/access
point.
1. Press and hold the WPS button on your wireless router/access point for
the correct length of time to activate its WPS.
Please check the instructions for your
wireless router/access point for how long
you need to hold down its WPS button to
activate WPS.
2. Within two minutes, press the WPS/Reset button on the network camera
for 2 – 5 seconds to activate WPS. The green LAN LED will flash slowly to
indicate that WPS is active.
Take care not to hold the WPS/Reset button too long and reset
your network camera.
3. The devices will establish a secure wireless connection. The green LAN LED
will flash quickly to indicate a successful WPS connection.
To Next Page
Loading...
