28
III. Outdoor Installation
Recommended installation:
The instructions below are a guide – if you are unsure please seek
professional assistance.
Disconnect the outdoor image unit from the indoor main unit and remove
the indoor main unit antenna and power cable before outdoor installation.
1. Establish the best respective locations for the camera’s outdoor and
indoor main unit.
It is recommended that the location of the outdoor image unit is also the
point where the cable will enter property, so that the cable can be
covered by the outdoor image unit.
2. Use the included wall template to drill holes of sufficient diameter in your
exterior wall to enable the outdoor image unit to be securely screwed into
place.
A power drill with masonry bit is recommended.
To Next Page
Loading...
