Use the green button to call up the menu for the search of channels according to the set values at the
item TP Index (Transponder Index). The following settings can be specified:
Search mode: Select here between the value All (channels) or Available (channels). With
the value All, encrypted and free-to-air channels are sought.
Program type: Specify here whether the TV, Radio or TV and Radio channels are sought.
Select search mode: Set here a 'Manual Search' or 'Blind Scan'.
NIT search: Set here whether the NIT (Network Information Table) should be used during
the search. This value is only changeable when setting the 'Manual Search'
value for the 'Select Search Mode' item.
Navigate with the up/down arrow buttons to the 'OK' button for search and then press the OK button
to start the search process. The menu window can be exited at any time with the EXIT button.
The blue button starts the automated detection of available satellites via DiSEqC. If satellites were
identified by means of installation and alignment of the satellite reception system, they will be
displayed. The following changeable settings can be reached via the 'Search' button.
Search mode: Select here between the values All (channels) or Available (channels). With
the value All, encrypted and free-to-air channels are sought.
Program type: Specify here whether the TV, Radio or TV and Radio channels are sought.
Select search mode: Set here a 'Manual Search' or 'Blind Scan'.
NIT search: Set here whether the NIT (Network Information Table) should be used during
the search.
The OK button starts the search process. The menu window can be exited at any time with the EXIT
button.
The white button (PLAYMODE button) starts a Blind Scan based on the above settings.
The 'MUTE’ button switches on or off a signal tone. Exit the 'Satellite Installation' menu with the EXIT
button.
To Next Page
Loading...
