Disarming The System
When you enter the premises after the system has been armed in AWAY Mode, or if you
have armed the system in STAY Mode 1 or STAY Mode 2, you will need to disarm the
system before entry time expires to disable detection devices that will activate an alarm.
Only your installer can program the entry time.
If there has been an alarm condition prior to disarming the system, a flashing zone indicator
will be displayed, indicating a previous alarm on that zone.
How To Disarm The System
1. Enter your user code followed by the # button (eg. 2580#).
Two beeps will be heard.
Adding User Codes
Only the Master Code holder can add or change other system user codes including the
Master Code itself. Up to eight user codes may be programmed to operate the system.
How To Add A User Code
1. Enter your Master Code followed by 1 and the # button (eg. 2580 + 1 + #).
Three beeps will be heard and the STAY and AWAY indicators will begin to flash.
2. Enter the user code number (1 – 8) that you wish to add or change followed by the #
button (eg. 2# = User 2 / 8# = User 8 etc). Two beeps will be heard and the user
number that you just selected will now display on the codepad indicators.
3. Enter the digits required for the new code followed by the # button (eg. If you wish the
user code to be 5768, you would enter 5768#). Two beeps will be heard and the
STAY and AWAY indicators will extinguish.
If you wish to add or change any further user codes, repeat this procedure as many
times as required.
Adding Radio Remote User Codes
Only the Master Code holder can add or change other system user codes (including the
Master Code itself). Up to eight radio user codes (User Codes 9 – 16) may be programmed
to operate the system.
How To Add A Radio Remote User Code
1. Enter your Master Code followed by 1 and the # button (eg. 2580 + 1 + #).
Three beeps will be heard and the STAY and AWAY indicators will begin to flash.
2. Enter the radio remote user code number (9 – 16) that you wish to add followed by the
# button (eg. 9# = User 9 / 16# = User 16 etc). Two beeps will be heard and the user
number that you just selected will now display on the codepad indicators.
3. Press a button on the keyfob so that the system will learn the ID number. Two beeps
will be heard and the STAY and AWAY indicators will extinguish.
If you wish to add or change any further radio remote user codes, repeat this procedure
as many times as required.
Solution 862 Operators Manual 13
Electronics Design and Manufacturing Pty Limited ISSUE110
To Next Page
Loading...
