Telco Arm/Disarm Sequence (Call Forward On/Off)
This feature allows you to program the Telco Arm Sequence and Telco Disarm Sequence.
Telco Arm Sequence
This allows you to program the Call Forward – Immediate On sequence or Call Forward –
No Answer sequence that will automatically operate when you arm the system in the AWAY
Mode. This feature is only available if your telecommunications provider has the call-
forward option available.
Note: The examples given in this feature are only applicable to Australia.
Call Forward – Immediate On
You can redirect calls to anywhere in Australia, including mobiles, pagers and answering
services. When Call Forward is turned on, your telephone will not ring.
Call Forward – No Answer
When your telephone is not answered within 20 seconds, this feature redirects all incoming
calls to another number anywhere in Australia, but you can still make outgoing calls.
How To Program The Telco Arm Sequence
1. Enter your Master Code followed by 3 and the # button (eg. 2580 + 3 + #).
Three beeps will be heard and the STAY and AWAY indicators will flash.
2. Press button 1 followed by the # to select the telco arm sequence. Three beeps will be
heard.
3. Enter the call forward sequence that you require (eg. *61 Phone Number # if you wish
to program the call forward - no answer sequence or *21 Phone Number # if you wish
to program the call forward immediate sequence).
Remember that when you program a * in the telco arm sequence, you enter *1
and when you program a # in the telco arm sequence, you enter *2.
4. Press the # button when finished.
Two beeps will be heard and the STAY and AWAY indicators will extinguish.
Note: To disable the Telco Arm Sequence, enter the call forward sequence as *4
(break) for Step 3.
20
Solution 862 Operators Manual
ISSUE110 Electronics Design and Manufacturing Pty Limited
To Next Page
Loading...