Turning Outputs On/Off
This feature is only applicable if your installer has set up an output that can be turned on or
off via the codepad. The output programmed by your installer could control a pool pump or
outside lighting etc. Up to three separate outputs may be programmed.
How To Turn An Output On or Off
1. Enter your Master Code followed by 5 and the # button (eg. 2580 + 5 + #).
Three beeps will be heard and the STAY and AWAY indicators will begin to flash.
2. Enter the output number (1 – 3) that you wish to turn on or off.
3. Press the # button to turn the output on or press the * button to turn the output off.
Three beeps will be heard if the output is turned on and two beeps will be heard if the
output is turned off.
Repeat Step 2 and Step 3 if more than one output is required to be turned on of off.
4. Press the # button to exit this function.
Two beeps will be heard and the STAY and AWAY indicators will extinguish.
Reset Latching Outputs
This feature is only applicable if your installer has programmed an output to latch (remain
on) until you acknowledge the event that occurred.
How To Reset Latching Outputs
1. Hold down button 7 until two beeps are heard.
The output will now reset.
Codepad Buzzer Tone Change
Holding down button 8 continuously will change the tone of the codepad buzzer. There are
fifty different tones to choose from between 1500 Hz – 5000 Hz. If multiple codepads have
been installed, each codepad can have a different tone.
22
Solution 862 Operators Manual
ISSUE110 Electronics Design and Manufacturing Pty Limited
To Next Page
Loading...