Code To Isolate
This method restricts only those user codes that have the priority level ‘Code To Isolate’ set
to be able to isolate zones. Therefore, if any user code has this priority level set, the method
of standard isolating will not function.
How To Isolate A Zone
1. Press the * button followed by your user code and the * button again to enter the
isolating mode (eg. *2580*). Three beeps will be heard and the STAY indicator will
flash.
2. Enter the zone number (1 – 8) that you wish to select to isolate followed by the *
button. (Eg. 1* = Zone 1, 2* = Zone 2 etc).
As you select each zone to be isolated, you will notice that the corresponding zone
indicator will begin to flash. If you selected an incorrect zone to be isolated, enter the
incorrect zone number again followed by the * button.
Repeat Step 2 if more than one zone is required to be isolated until all zone that are
required to be isolated have been selected.
3. Press the # button after you have selected all zones to be isolated.
Two beeps will be heard and the system will return to the disarmed state.
Date and Time
Programming the date and time is only required when you need functions such as automatic
test reports automatic arming and history events to operate correctly.
How To Program The Date and Time
1. Enter your Master Code followed by 6 and the # button (eg. 2580 + 6 + #).
Three beeps will be heard and the STAY and AWAY indicators will begin to flash.
2. Enter the day, month, year, hour and minute using the (DD, MM, YY, HH, MM)
format (ie. DD = Day of the month, MM = Month of the year, YY = Current year, HH
= Hour of the day, MM = Minute of the day).
Please note that when programming the hour of the day, you will need to use
24:00 hour format.
3. Press the # button to exit and return to the disarmed state.
Two beeps will be heard and the STAY and AWAY indicators will extinguish. If a
long beeps is heard, an error was made when entering the date and time.
Solution 862 Operators Manual 17
Electronics Design and Manufacturing Pty Limited ISSUE110
To Next Page
Loading...
