Figure 5: CP5 LED
Codepad Showing Audible
Alarm Buttons
Duress Alarm
A codepad duress alarm is used as a silent hold-up alarm. This will only occur when the
number 9 is added to the end of any valid user code that us being used to disarm the system
(eg. 2580 + 9#). A duress alarm is only useful if your system is reporting back to a
monitoring station or pocket pager as domestic reporting (ie. mobile phone etc) can’t
decipher which type of alarm had occurred.
Panic Alarm
An audible alarm will be activated when both the 1 and 3 buttons or both the *
and # buttons are pressed simultaneously. Contact your installer if you wish to
disable the ability to activate the codepad panic alarm or if you wish to have the
codepad panic alarm to be silent.
Fire Alarm
A distinct fire sound is emitted via the horn speaker when both the 4 and 6
buttons on the codepad are pressed simultaneously. Contact your installer if you
wish to disable the ability to activate the codepad fire alarm or if you wish to
have the codepad fire alarm to be silent.
Medical Alarm
An audible alarm will be activated when both the 7 and 9 buttons on the
codepad are pressed simultaneously. Contact your installer if you wish to
disable the ability to activate the codepad medical alarm or if you wish to have
codepad medical alarm to be silent.
Tamper Alarm (Access Denied)
Codepad tamper restricts the number of times an invalid user code can be used in an attempt
to operate the system. When the number of incorrect code attempts equals the number
programmed by your installer, the system will activate an alarm condition and if reporting
back to a security monitoring station, the system will send an access denied report.
If you wish the codepads to shutdown and lockout for a period of time (0 – 150 seconds), ask
your installer to program this.
Solution 862 Operators Manual 15
Electronics Design and Manufacturing Pty Limited ISSUE110
To Next Page
Loading...
