Term Description
Isolating
Allows you to manually disable (isolate) one or more zones before arming the
system.
Master Code
Is a numerical code used for arming and disarming the system as well as allowing
access to functions such as adding and deleting user codes etc.
Monitoring Station
Is a secure location where a digital receiver monitors numerous alarm systems and
deciphers their alarm transmission reports. The operator can then advise the
appropriate authorities to take immediate action.
Panic Alarm
This type of alarm indicates to the monitoring station that there is an emergency
situation at your premises.
Sealed
Refers to zone status. If a zone is sealed, the detection device is not violated an
the zone indicator will not be displayed on the codepad.
Sensor Watch
Sensor watch gives the control panel the ability to recognise that detection devices
may have stopped working or that the view to a PIR detector has been blocked,
thus unable to detect any movement over the duration of the time programmed by
your installer.
Silent Alarm
Your installer may program zones for silent operation. This means that when the
zone programmed for silent operation has been violated during the armed period,
your alarm system will communicate with the monitoring station without sounding
the sirens.
STAY Mode 1
Is a condition that automatically isolates zones when your system is armed in
STAY Mode 1. Only your installer can program zones to be isolated automatically
in STAY Mode 1.
STAY Mode 2
Is a condition that automatically isolates zone when your system is armed in STAY
Mode 2. Only the Master Code holder can program zones to be isolated
automatically in STAY Mode 2.
Telco Arm Sequence
Telco arming is a feature that automatically calls the telephone exchange an
diverts your telephone number to another telephone when the system is armed in
AWAY Mode (In Australia, this feature is called “Call Forward”).
Telco Disarm Sequence
Telco disarming automatically calls the telephone exchange and un-diverts you
telephone number.
Unsealed
Refers to zone status. A zone is unsealed when a zone has been violated. The
corresponding zone indicator will display on the codepad.
User Code
A user code is the personal identification number that the operator uses to arm an
disarm the system.
Zones
A monitored input used to trigger an alarm condition when violated.
24-Hour Zones
A monitored input programmed to trigger an alarm condition when violated when
the system is armed or disarmed 24-hours a day.
30
Solution 862 Operators Manual
ISSUE110 Electronics Design and Manufacturing Pty Limited
To Next Page
Loading...
