EDWARDS SYSTEMS TECHNOLOGY IRC-3 - CM1(N) Operation Details; Test Mode Status and Time Controls; Generating Sensitivity Reports

Operations Manual 7
Disabled Messages. Use Next to scroll
• Press the Next/Ack button to scroll the display. The display shows
the following:
Disabled Actions. Use Next to scroll
• Press the Next/Ack button to scroll the display. The display shows
the following:
Disabled Sequences. Use Next to scroll
• Press the Next/Ack button to scroll the display. The display shows
the following:
Test Mode Active
====Panel #pp ====
• Press the Next/Ack button to scroll the display. The display shows
the following:
Disabled Time Ctrls. Use Next to scroll
1030/1600/
Sensitivity Report
Generates device sensitivity listing.
• Press the Test/Stat button. The display shows the following:
1) Test 2) Status 3) Sensitivity Report
4) History Enter # Choice ->_
The Test/Prgm LED flashes.
A printer is required to output the sensitivity report. The printer will be
automatically enabled (if disabled) when a sensitivity report is
requested.
• Key in “3” (Sensitivity Report) and press the Enter button. The
display shows the following:
Enter Panel Address or DEL to abort
Enter # Choice ->_
• Key in panel address and press the Enter button. The display returns
to normal.
The sensitivity report will output to the printer. Additional information
on sensitivity reports may be found in the Sensitivity Reports section.
firealarmresources.com