EDWARDS SYSTEMS TECHNOLOGY IRC-3 - CM1(N) System Configuration; Enabling Specific System Features

Operations Manual 13
Enable Zone
1) Zone 2) Znmsg 3) Tmctrl 4) Datlne 5) Panel
6) Actn 7) Seqnc Enter Choice->_
• Key in “1“ (Zone) and press the Enter button. The display shows the
following:
Enable a Zone or Device
Enter Device Address (ppzz) ->_
pp = 2-digit panel number
zz = 2-digit zone number
• Key in the 4-digit address of the zone or device that you want to
enable and press the Enter button.
The selected zone or device is enabled. The display returns to normal.
Enable Zone Message
1) Zone 2) Znmsg 3) Tmctrl 4) Datlne 5) Panel
6) Actn 7) Seqnc Enter Choice->_
• Key in “2“ (Znmsg) and press the Enter button. The display shows
the following:
Enable a Zone or Device’s message
Enter Device Address (ppzz) ->_
pp = 2-digit panel number
zz = 2-digit zone number
• Key in the 4-digit address of the zone or device whose message you
want to enable and press the Enter button.
The selected zone or device’s message is enabled. The display returns
to normal.
Enable Time Controls
1) Zone 2) Znmsg 3) Tmctrl 4) Datlne 5) Panel
6) Actn 7) Seqnc Enter Choice->_
• Key in “3“ (Tmctrl) and press the Enter button. The display shows
the following:
Enable a Time Control
Enter Time Control # (tttt)->_
tttt = Action number that corresponds to time in 24-hour, military
format
• Key in the 4-digit time control # and press the Enter button.
firealarmresources.com