Edwards D397-00-000

Index
D397-21-880 Issue G
© Edwards Limited 2009. All rights reserved. Page 39
Edwards and the Edwards logo are trademarks of Edwards Limited.
A
Accessories ............................................... 37
Active gauge connectors .................................3
Additional earth bonding
............................... 12
Alarms ..................................................... 30
Analogue outputs ..........................................6
B
Bench mounted TIC dimensions (mm) ................ 10
C
Changing list items ...................................... 20
Changing numerical values
............................. 20
Cleaning the controller
................................. 34
Component checklist ......................................9
Connecting an active gauge ........................... 13
Connecting the electrical supply
...................... 12
Connecting the serial interface ....................... 14
Connections ................................................3
Controller electrical connections
..................... 12
D
Disposal ................................................... 35
E
Electrical data .............................................3
Electrical supply ...........................................3
Electrical supply failure
................................ 32
Entering negative components ........................ 21
F
Factory defaults ......................................... 34
Fault finding .............................................. 33
Fitting the controller
.....................................9
Front panel display
...................................... 17
Fuse ..........................................................3
G
Gauge order set up ...................................... 32
Gauge setup .............................................. 21
I
Installation .................................................9
L
Linking gauges ........................................... 30
Logic interface
.............................................4
M
Maintenance .............................................. 33
Mechanical data ...........................................3
Menu structure .......................................... 18
O
Operating and storage data .............................3
Operation ................................................. 17
Organising gauges on the view screen ............... 32
P
Pin allocation for analogue outputs ....................7
Pin connection for 4-way analogue output connector
6
R
Relay setpoint outputs ................................. 32
S
Safety ..................................................... 33
Scope and definitions
.....................................1
Serial communications ...................................5
Serial communications connector pin-out .............6
Service
.................................................... 37
Service information ..................................... 32
Software updates ........................................ 34
Spares
..................................................... 37
Storage .................................................... 35
Storage and disposal .................................... 35
T
Technical data .............................................3
U
Unpack and inspect .......................................9
Using control inputs ..................................... 13
Using status outputs
.................................... 13
V
View screen shortcuts .................................. 18
Index